This forum is now read-only
To login to the new support channel and community forums, go to the Support Portal
HELP - Digital pre infusion module installation problem
Hi
I’m almost done with the installation, everything went quite well until I got to the spare manifold nub and just can’t take it off. I’ve been banging on it like shown on the video, it won’t budge a bit. I’ve tried to hit quite hard like it was suggested, it just stuck.
I don’t know what to do next please help
Thanks
Dominique
I’m almost done with the installation, everything went quite well until I got to the spare manifold nub and just can’t take it off. I’ve been banging on it like shown on the video, it won’t budge a bit. I’ve tried to hit quite hard like it was suggested, it just stuck.
I don’t know what to do next please help
Thanks
Dominique
Comments
keep banging away - but have an assistant hold the bottom end of the manifold to support it and prevent it from twisting around and putting too much load on the bracket
you are welcome to FaceTime me right now ([email protected]) or WhatsApp (+642040564412), both are free and its 13:40 on a saturday here
reiss.
I don’t have spare hands but i can nudge something behind the manifold to keep it from moving
Should I go for delicate bangs or more forceful ones?
Dominique
it is the percussion that shocks it apart
what weight of hammer are you using?
i prefer something closer to a 12oz, have you got a hammer more in that range?
hold it half way up the handle too for more control
let me know
reiss.
I have one but i have to locate it...new home and such
I’ll let you know when I’ve tried with the heavier one
Thanks again
Dominique
Attached files
The only hammer I found was a 16 oz.
I must have hit it like 50 times at least and nothing is moving.
What next?
Thanks
Dominique
That was not with tact and care ;-)
I can confirm they can be on tight
Finished the installation everything looks good to go
Many thanks for the support
Dominique
Attached files