This forum is now read-only
To login to the new support channel and community forums, go to the Support Portal
Dimension/Footprint question
i've got the overall dimensions, but the one number I didn't see in the schematic drawing was the rear foot center to front foot center distance. I'm trying to figure out if the L1 will fit the buffet on which my Ellimatic is dwelling or if I'm going to need to pick up a new cart/stand/table/whatever. Could some kind soul with both an L1 and a ruler post that measurement from front to rear foot centers?
And Reiss, if you ever touch up that dimensional drawing, you might consider adding that to it, for potential buyers like me who might not care if the drip tray or rear of the machine overhang a table a smidge.
Thanks, all!
And Reiss, if you ever touch up that dimensional drawing, you might consider adding that to it, for potential buyers like me who might not care if the drip tray or rear of the machine overhang a table a smidge.
Thanks, all!
Comments
Rear foot to front foot, center to center, measurement from my LI = 475mm (FWIW width between the front feet, again center-to-center, is 220mm)
The outside to outside measurement, front to back, for the feet is 20-1/8" (511.18mm). So, yes, the table/cart top should be minimum 20" front to back.
probably allow about 6mm (1/4") more as the series 2 chassis is slightly longer
a big thank you to dan for replying before i could get to it too, much appreciated
if you are using a trolley be sure to keep the centre of mass as low as possible in it to reduce the probability of it tipping - i.e. if you're going to fill it with heavy stuff put it right at the bottom
the images i see of the product on the net show it with wheels on 2 legs only - i think you should position the cart with the 2 wheeled legs at the back - that way if the trolley goes light at the back when you pull the shot there are no castors at the front, but just fixed legs, which should prove to be a lot less exciting in a worst case scenario
best
reiss