This forum is now read-only
To login to the new support channel and community forums, go to the Support Portal
Seals question
Hi Riess,
I've noticed that the grab point on my lever has become much more vertical than normal lately, so I'm getting much less volume is espresso.
Are you able to let me know if this is because I need to replace group / piston seals?
Thanks. Matt
I've noticed that the grab point on my lever has become much more vertical than normal lately, so I'm getting much less volume is espresso.
Are you able to let me know if this is because I need to replace group / piston seals?
Thanks. Matt
Comments
yes, that is correct, it is time to replace the seals if the lever will not grab 45 degrees or more below vertical
if you are not aware there is a painstaking how to change the piston seals video in the permanent file of this forum
let me know if you have further questions
have a pleasant easter as you welcome spring
reiss.
I've ordered the seals and watched the videos, which were really helpful.
Thanks
Matt