This forum is now read-only
To login to the new support channel and community forums, go to the Support Portal
Improving drip tray drain capabilities
The drip tray is flat. There is no inclined surface to the hole in the middle of the tray. So water would sit around the drip tray. Table is leveled, tray is leveled, without any inclined around the drain hole, water would just sit. Easy fix...
Grabbed some rubber pads... a smooth metal ball tool used for removing dents from metal... placed tray on the rubber pads, used some thick leather between the tray and the metal tool (hey, is still has to look nice, smooth, and shiny! )... hit it with a big hammer and voila!
Perfect indentation and now the water flows to the drain...
This one was kind of hard to photograph... but you get the idea... needed an inclined for all sides of drain hole...
Grabbed some rubber pads... a smooth metal ball tool used for removing dents from metal... placed tray on the rubber pads, used some thick leather between the tray and the metal tool (hey, is still has to look nice, smooth, and shiny! )... hit it with a big hammer and voila!
Perfect indentation and now the water flows to the drain...
This one was kind of hard to photograph... but you get the idea... needed an inclined for all sides of drain hole...
Attached files
